Setting Up as a Electronic Repair Authorized Service Center

Written by Jestine Yong


Continued from page 1
• Reception Area – A proper reception area, neat and tidy workshop will reflect on them as well. First impression count a lot. • Tools and Test Equipment – The variety of tools and test equipment available will be taken into account. An oscilloscope, frequency counter, SMD rework station is a certain requirement. The work bench should be of decent size and comes with a fluorescent lighting. • Employee – There must be enough of employee to cope up withrepparttar work of repair.

Prolong or continuous delay of repair will make them to reconsider of changing to another service center.

To run an Authorized Service Center needs total dedication, but it will bring you into contact with a lot of people, some of who can be quite influential. It can also widenrepparttar 138980 product range that comes your way

Jestine Yong is a electronic repairer and a writer. For more repair information, please visit http://www.noahtec.com


What is ESR METER ?

Written by Jestine Yong


Continued from page 1

» Low ohms resistor such as 0.22 ohm, 0.33 ohm and etc. » Horizontal yoke coil winding of a picture tube, inductor and primary winding of a transformer – If a shorted turn is present,repparttar inductance drops dramatically andrepparttar 138979 meter will showrepparttar 138980 ohms reading. » Horizontal output transistor (HOT) in a monitor or TV – If an open-circuit reading is obtained,repparttar 138981 short-circuit is elsewhere. Ifrepparttar 138982 short-circuit remains,repparttar 138983 transistor is faulty. » Short-circuit inrepparttar 138984 track, usually trace torepparttar 138985 components - You can userepparttar 138986 ESR meter to locate short-circuits on printed circuit boards by measuringrepparttar 138987 actual track resistance. Ifrepparttar 138988 reading increases as you probe further alongrepparttar 138989 track, you know you’re going inrepparttar 138990 wrong direction! » Speakers, amplifier etc - The pulses have a fast rise/fall time, so it would probably make a crude RF signal injector as well. » The condition of bothrepparttar 138991 normal and rechargeable batteries – Flat and faulty battery will have high ESR.

Jestine Yong is a electronic repairer and a writer. For more repair information, please visit http://www.noahtec.com


    <Back to Page 1
 
ImproveHomeLife.com © 2005
Terms of Use