Burning Bridges is Bad, But Firewalls are GoodWritten by Heather Wallace
When you signed up for that ultra-fast DSL or Cable connection there was probably one very important piece of information that your ISP failed to mention. By accessing Internet via a high-speed connection, you have tremendously increased your chances of being victimized by a computer hacker.Dial-up may not have seemed like it could have held any advantages, but it actually did have one upside. It is much less prone to hacking. Every time you dialed-in your computer was assigned a new IP address. That unique IP address made you a moving target that was more difficult for hackers to hit. With a high-speed connection you are assigned a static IP address (it never changes). So, your computer went from being a moving target to staying still with a bulls-eye pasted on side. That, coupled with fact that with a high-speed connection your computer is always online, are ideal conditions for a potential hacker attack. That seemingly beneficial always-on connection gives hackers a 24/7 open invitation to try and hack your system. Once inside they can access personal or financial details, compromise your computer's operating system, or unleash a virus, worm, or spyware. Which Firewall is Right For You? Now that you know how vital a firewall is to protection of your PC you have to decide which firewall is right for you. Software or hardware. A software firewall is designed to monitor your computers activity at all times. Think of it as a bodyguard who won't let anyone into your computer if he doesn't like look of them. With a software firewall you may to have to assist in protecting your system. The firewall might alert you to certain activity and ask you if you want to grant or deny permission. It's just like bodyguard that was mentioned before. He needs okay before telling someone to scram. After you give either thumbs up or thumbs down firewall will take appropriate action and remember your reply so that you won't be asked in future.
| | How to transfer Autocad drawings for use in Solidworks softwareWritten by Adrian Dunevein
How to prepare Autocad drawing borders for use in Solidworks.If you have begun using Solidworks for your 3D modeling it’s quite likely you have amassed lots of Autocad drawings over years. More than likely, you would like to continue using same look and feel in drawing borders you make in Solidworks. You can import Autocad drawing borders into Solidworks but there is some preparation you should do before attempting it. This preparation will make sure that you can copy back to Autocad in future with minimal problems. Lets assume you have opened a sample Autocad drawing and you have entire drawing border visible on screen. Start by making sure your drawing border and title block, bill of material and revision blocks are only things visible. You can leave text in title blocks, you can always edit it later in Solidworks. Same applies to drawing numbers, revision numbers and any other textual information that might need to be placed on every drawing you create. Make sure your drawing border is actual size it is supposed to be. If this is a D size drawing for example, draw a rectangle 24” x 36” around drawing border and see if border fits inside. If not, scale border until it does. Locate lower left corner of rectangle you have drawn and move it and whole drawing border, rectangle and all to location 0,0,0 in model space or paper space.
|